Using the Run button options

Clicking the Run button runs a full-load replication task from the source to the target. This is a first time task that creates the target endpoints and loads the source data to the target according to your task definitions.

Subsequent runs allow you to resume processing from a specific point and process changes. In addition, you can also specify from what point you want the replication to start.

The following options are available:

• Start Processing - This is available the first time you run the task only. This will execute the initial full load operation. If Change Processing is also enabled for the task or if it is an Apply Changes only task type, change processing will start as soon as any changes are made to the source endpoint.(switches to Resume Processing after the task has started)

• Resume Processing - Resumes task execution from the point that it was stopped. You can also resume processing by clicking the Run button if the task has been stopped.

  Information note

  If the schema or a filter was changed after the task stopped, the task should be reloaded as opposed to resumed (see below).

• Reload Target (Only available when the Full Load or Full Load and Apply Changes replication options are enabled) - Starts the Full Load and Change Processing (if enabled) from the beginning. Tables that have already been processed are handled according to the relevant "Target table preparation" setting.

  Information note

  To replicate tables that were added to the local file channel task after the initial full load, you need to reload both the local and the remote file channel tasks.

• Advanced run options - Advanced options for controlling task execution. For more information, see Advanced Run Options